11. Measure the resistance between ACC unit 20P connector terminal No. 5 and body ground. There should be an open circuit or at least 1
MOhms.
Is the resistance as specified?
YES -
Go to step 12.
NO -
Repair a short to ground in the wire between the ACC unit and the right front brake fluid pressure sensor.?
12. Disconnect the right front brake fluid pressure sensor 3P connector.
13. Connect right front brake fluid pressure sensor 3P connector terminal No. 2 to body ground with a jumper wire.
14. Measure the resistance between ACC unit 20P connector terminal No. 5 and body ground. There should be less than 1.0 Ohms.
Is the resistance as specified?
YES -
Go to step 15.
NO -
Repair an open in the wire between the ACC unit and the right front brake fluid pressure sensor.?
15. Remove the jumper wire from the right front brake fluid pressure sensor.
16. Reconnect all connectors.
17. Turn the ignition switch to ON (II).
18. Measure the voltage between ACC unit 20P connector terminals No. 3 and No. 5. There should be about 5 V.
