Tuesday, June 16, 2020

2010 Acura Truck MDX V6-3.7L Page 571


Side Case Replacement.?



NO -



Update the SH-AWD control unit if it does not have the latest software See: Powertrain Management/Transmission Control Systems/Relays and



Modules - Transmission and Drivetrain/Relays and Modules - Differential/Control Unit/Testing and Inspection/SH-AWD Control Unit Update, or



substitute a known-good SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission



and Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair, and recheck. If the symptom/indication goes away with the



updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit,



replace the original SH-AWD control unit See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and



Drivetrain/Relays and Modules - Differential/Control Unit/Service and Repair.?



57-2



SH AWD DTC Troubleshooting: 57-2



DTC 57-2:



Right Clutch Electromagnetic Coil (Short)



NOTE: Before you troubleshoot, review the general troubleshooting information See: Transmission and Drivetrain/Differential Assembly/Testing



and Inspection/Initial Inspection and Diagnostic Overview.



1. Turn the ignition switch to ON (II).



2. Clear the DTC with the HDS.



3. Do the clutch function test with the HDS See: Transmission and Drivetrain/Differential Assembly/Testing and Inspection/Component Tests



and General Diagnostics.



4. Check for DTCs with the HDS.



Is DTC 57-2 indicated?



YES -



Go to step 5.



NO -



Intermittent failure, the system is OK at this time.?



5. Turn the ignition switch to LOCK (0).



6. Disconnect SH-AWD control unit connector B (8P) and the right solenoid 4P connector.



7. Check for continuity between SH-AWD control unit connector terminals B6 and B7.



Is there continuity?



YES -



Repair a short in the wires between SH-AWD control unit connector terminals B6 and B7.?



NO -



Go to step 8.



8. Turn the ignition switch to ON (II).



9. Measure the voltage between SH-AWD control unit connector terminal B6 and body ground.