YES -
Go to step 5.
NO -
Intermittent failure, the system is OK at this time. Check for loose or poor connections between the relay control module and the gauge control
module.?
5. Check for DTCs with the HDS.
Are DTCs B1011, B1060, B1061, B1205, B1357, B1359, B1805, B1808, B1906, B1956, B2160, and U0155 all indicated?
YES -
Do the gauge control module input test See: Instrument Panel, Gauges and Warning Indicators/Testing and Inspection/Component Tests and
General Diagnostics/Gauge Control Module Input Test.?
NO -
Do the relay control module input test See: Power and Ground Distribution/Testing and Inspection/Relay Control Module Input Test.?
B1061
DTC Troubleshooting: B1060, B1061
DTC B1060:
Relay Control Module Lost Communication with Gauge Control Module (VSP/NE Message)
DTC B1061:
Relay Control Module Lost Communication with Gauge Control Module (A/T Message)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back to ON (II).
3. Wait for at least 6 seconds.
4. Check for DTCs with the HDS.
Are DTCs B1060 and/or B1061 indicated?
YES -
Go to step 5.
NO -
Intermittent failure, the system is OK at this time. Check for loose or poor connections between the relay control module and the gauge control
module.?
5. Check for DTCs with the HDS.
Are DTCs B1011, B1060, B1061, B1205, B1357, B1359, B1805, B1808, B1906, B1956, B2160, and U0155 all indicated?
YES -
Do the gauge control module input test See: Instrument Panel, Gauges and Warning Indicators/Testing and Inspection/Component Tests and
General Diagnostics/Gauge Control Module Input Test.?
NO -
Do the relay control module input test See: Power and Ground Distribution/Testing and Inspection/Relay Control Module Input Test.?
