14. Reconnect power tilt/telescopic steering control unit connector A (16P).
15. Turn the ignition switch to ON (II).
16. Measure the voltage between power telescopic motor/position sensor 6P connector terminals No. 4 and No. 6 and between terminals No. 5
and No. 6.
Is there about 5 V?
YES -
Faulty power telescopic motor/position sensor, replace the telescopic motor assembly.?
NO -
If there is no voltage, replace the power tilt/telescopic steering control unit. If there is battery voltage, repair a short in the wire.?
17. Turn the ignition switch to LOCK (0).
18. Disconnect power tilt/telescopic steering control unit connector A (16P).
19. Disconnect the power telescopic motor/position sensor 6P connector.
20. Check for continuity between power tilt/telescopic steering control unit connector A (16P) terminals No. 2 and No. 16 and power
telescopic motor/position sensor 6P connector terminals No. 3 and No. 6 respectively.
Is there continuity?
YES -
Go to step 21.
NO -
Repair an open in the wire.?
21. Disconnect the power tilt motor/position sensor 8P connector.
22. Check for continuity between power telescopic motor/position sensor 6P connector terminal No. 3 and body ground.
