8. Check the ON/OFF information of the Driver's Door Knob Switch (LOCK) and Driver's Door Lock Knob Switch (UNLOCK) in the DATA
LIST.
Are both information indicators OFF?
YES -
Faulty driver's door lock knob switch; replace the driver's door lock actuator assembly.?
NO -
Go to step 9.
9. Turn the ignition switch to LOCK (0).
10. Disconnect driver's MPCS unit connector A (40P).
11. Check for continuity between body ground and driver's door lock actuator 10P connector terminals No. 6 and No. 7 individually.
Is there continuity?
YES -
Repair a short to ground in the wire.?
NO -
Replace the driver's MPCS unit.?
B2182
DTC Troubleshooting: B2182
DTC B2182:
Left Power Mirror Horizontal Sensor Signal Error
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back to ON (II).
3. Move the left power mirror in each direction with the power mirror switch.
4. Check for DTCs with the HDS.
Is DTC B2182 indicated?
YES -
Go to step 5.
NO -
Intermittent failure, the system is OK at this time. Check for loose or poor connections.?
5. Select POWER SEAT/POWER MIRROR from the BODY ELECTRICAL menu, and enter the DATA LIST.
