Repair a short to ground in the wire.?
NO -
Go to step 12.
12. Check for continuity between driver's door wire harness A 16P connector terminals No. 3 and No. 6.
Is there continuity?
YES -
Repair a short in the wires.?
NO -
Go to step 13.
13. Reconnect driver's MPCS unit connector A (40P).
14. Turn the ignition switch to ON (II).
15. Measure the voltage between driver's door wire harness A 16P connector terminal No. 3 and body ground.
Is there about 5 V?
YES -
Replace the left power mirror.?
NO -
Replace the driver's MPCS unit.?
B2184
DTC Troubleshooting: B2184
DTC B2184:
Right Power Mirror Horizontal Sensor Signal Error
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting
- B-CAN System Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back to ON (II).
