2010 Acura Truck MDX V6-3.7L Page 74

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A See: Powertrain

Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting

- B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Wait for at least 15 seconds.

3. Check for DTCs with the HDS.

Is DTC B1192 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the battery sensor is OK at this time.?

4. Check the No. 9 (7.5 A) fuse in the main under-hood fuse box.

Is the fuse OK?

YES -

Go to step 5.

NO -

Replace the fuse, and recheck the system. If the fuse is blown again, repair a short in the wire.?

5. Turn the ignition switch to LOCK (0)

6. Disconnect the battery sensor 2P connector.

7. Measure the voltage between battery sensor 2P connector terminal No. 2 and body ground.

Is there battery voltage?

YES -

Go to step 8.

NO -

Repair an open in the wire between the main under-hood fuse box and the battery sensor.?

8. Disconnect gauge control module connector B (24P).

9. Measure the voltage between battery sensor 2P connector terminal No. 1 and body ground.

2010 Acura Truck MDX V6-3.7L Page 175

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A See: Powertrain

Management/Computers and Control Systems/Information Bus/Testing and Inspection/Component Tests and General Diagnostics/Troubleshooting

- B-CAN System Diagnosis Test Mode A.

1. Connect the HDS to the DLC.

2. Clear the DTCs with the HDS.

3. Turn the ignition switch to LOCK (0), and then back to ON (II).

4. Check for DTCs with the HDS.

Is DTC B1775 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time.?

5. Turn the ignition switch to LOCK (0).

6. Disconnect the roof console 20P connector.

7. Disconnect the HandsFreeLink control unit 28P connector.

8. Turn the ignition switch to ON (II).

9. Measure the voltage between HandsFreeLink control unit 28P connector terminal No. 13 and body ground.

Is there battery voltage?

YES -

There is a short to power in the wires between the HandsFreeLink control unit and the HFL microphone. Replace the affected shielded harness.?

NO -

Go to step 10.

10. Turn the ignition switch to LOCK (0).

11. Check for continuity between HandsFreeLink control unit 28P connector terminal No. 13 and roof console 20P connector terminal No. 20.