Sunday, April 19, 2020

2010 Acura Truck MDX V6-3.7L Page 710


Is DTC 86 indicated?



YES -



Check for loose terminals in the VSA modulator-control unit 46P connector. If the VSA modulator-control unit was updated, substitute a



known-good VSA modulator-control unit See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Traction Control



Module/Service and Repair, then retest. If the VSA modulator-control unit was substituted, go to step 1.



NO -



If the VSA modulator-control unit was updated, troubleshooting is complete. If the VSA modulator-control unit was substituted, replace the



original VSA modulator-control unit See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Traction Control



Module/Service and Repair. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.?



86-1x



SRS DTC Troubleshooting: 86-1x, 86-2x



DTC 86-1x ("x" can be 0 thru 9 or A thru F):



Faulty OPDS Seat-Back Sensor



DTC 86-2x ("x" can be 0 thru 9 or A thru F):



Faulty OPDS Seat Support Sensor



NOTE:



- Before doing this troubleshooting procedure, review SRS Precautions and Procedures See: Body and Frame/Air Bag(s) Arming and



Disarming/Service and Repair and General Troubleshooting Information See: Restraints and Safety Systems/Air Bag Systems/Testing and



Inspection/Reading and Clearing Diagnostic Trouble Codes.



- Before replacing the SRS unit, check the SRS unit software version with the HDS. If the software version is not the latest, update the SRS



unit software See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Programming and Relearning/SRS Unit Update,



and retest.



1. Clear the DTCs with the HDS.



2. Turn the ignition switch to ON (II), then wait for 10 seconds.



3. Check for DTCs with the HDS.



Is DTC 86-1x or 86-2x indicated?



YES -



Go to step 5.



NO -



Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.?



4. Turn the ignition switch to LOCK (0).



5. Check the connection at the ODS unit harness 18P connector (A) and OPDS sensor connectors (B) and ODS unit.