15. Turn the ignition switch to ON (II).
16. Measure the voltage between slide position sensor 4P connector terminals No. 2 (+) and No. 3 (-).
Is there about 5 V?
YES -
Faulty slide position sensor, replace the slide motor.?
NO -
If there is no voltage, replace the power seat control unit. If there is battery voltage, repair a short in the wire (sensor line).?
17. Turn the ignition switch to LOCK (0).
18. Disconnect power seat control unit connector A (40P).
19. Disconnect the slide position sensor 4P connector.
20. Check for continuity between power seat control unit connector A (40P) terminals No. 15 and No. 29 and slide position sensor 4P connector
terminals No. 1 and No. 3 respectively.
Is there continuity?
YES -
Go to step 21.
NO -
Repair an open in the wire.?
21. Disconnect the 4P connector from the front up-down position sensor and the rear up-down position sensor, then disconnect the driver's seat
wire harness 8P [14P] connector.
[ ]: With seat ventilation
22. Check for continuity between body ground and slide position sensor 4P connector terminal No. 1.
