8. Turn the ignition switch to ON (II).
9. Measure the voltage between body ground and ODS unit harness 18P connector terminal No. 1. There should be battery voltage.
Is there battery voltage?
YES -
Go to step 10.
NO -
Open in the right engine compartment wire harness, floor wire harness, or ODS unit harness; replace the faulty harness, then clear the DTC.?
10. Turn the ignition switch to LOCK (0).
11. Measure the resistance between body ground and ODS unit harness 18P connector terminal No. 12. There should be less than 1.0 Ohms.
Is the resistance as specified?
YES -
Go to step 12.
NO -
Open in the floor wire harness or ODS unit harness, or poor connection at the ODS unit harness 18P connector and the ODS unit. Check the ground
connection at G605. Check the connection; if the connection is OK, replace the faulty harness, then clear the DTC.?
12. Disconnect the negative cable from the battery, then wait at least 3 minutes.
